A robust build and simple, accessible construction makes the Phoenix Fury burner a great cost-effective choice. Compared to other open-fired designs, the Fury burner achieves better emissions and fuel-efficiency by putting 50% more combustion air through the burner.

Simple construction makes burner maintenance easy.

The compact flame enables the Fury burner to work with virtually all drum designs.

Low Cost

Success in the aggregate and HMA industries depends on profitability. The Astec Phoenix Fury burner is the low cost alternative to more expensive total air designs.

Simplicity

The simple and accessible construction makes burner maintenace easy: while it’s rugged build keeps maintenance costs to a minimum.

Efficiency

Rapidly swirling, high-energy air is the key to the Fury burner’s efficient combustion. The swirling air and flame are created by the fixed internal spin vanes, high-pressure blower, and high velocity nose.

Compact Flame Shape

The Phoenix Fury burner cleanly and efficiently burns oil or gas. Its compact flame makes it compatible with virtually all drum designs without complicated adjustments.

Better Emissions

The Astec Fury burner is designed to put 50% more combustion air through the burner than competitive designs. This means higher combustion quality, better emissions, and higher efficiency combustion throughout the entire firing range of the burner.

No Compressed Air

The Astec designed pre-filming fuel nozzle utilizes the combustion air from the high-pressure blower to atomize fuel. This eliminates the need for compressed air at the burner, and helps increase nozzle life.

Reliability

Each burner is also thoroughly tested before leaving the Astec burner facility to make start-up at your facility as fast as possible. For the most reliable oil light-off, even under cold and harsh conditions, the Fury burner is supplied with Astec’s exclusive heat tracing and insulation system.

BURNER FIRING SPECIFICATIONS
	Rated Capacity MBTU/HR	Nominal Aggregate Drying Capacity at 5% Moisture (tph)	Burner Air Capacity SCFM	Integral Blower Horsepower
	50	200	6,875	60
	75	300	10,313	75
	100	400	13,750	125
Above conditions are standard at 70° at sea level. See detailed capacity, performance sheets for each size for more information and specific flows and pressures. Nominal aggregate drying capacity based on typical exhaust stack temperatures of 240° F, 0.2 BTU/Lbm F specific heat in the aggregate. Burner maximum design capacity is the same as its rated capacity.